ez-duzit's latest activity

My grandfather had a miniature lighthouse on his mantle and even though I haven't seen it for 68 years I still remember. Here's my...

Nowhere in your original post did you quote that question. So it was taken as a blanket statement.

I think you missed the point. Don't expect Youtube to give you all the right answers to every problem. Though I have machines, such as...

One drill-press-type operation at which a mill excels, because of its large X-Y table, is precisely spacing holes.

Nice shop!

Now down to just 3 drill presses, which take up less room than the mill. I customize yachts. So the work is quite varied. I keep the...

Attaboy for the perseverance.

Part 3 Then came the exhaust! The manifolds were corroded at the mating surface...so onto the mill... After some clean up these looked...

Part 1 Oh boy...it's been forever..... Let me try to update this thread. Current status in the garage... back to the bike project...

Part 2 So when the engine was removed, the mechanical fuel sensor broke....these are filled with ether and act as a closed loop...

Upon installing the gauge, I noticed the shift indicator here would not sit in Park! The gauge came back out and the tiny Bowden...

This is the reason I recommended the Artu bit above. I believe Artu might have been the original “multipurpose” bit if this sort on...

I would use a new, quality (made in US), SHORT, Cobalt drill of ~5/32" for the pilot hole. Use high sulfur, pipe thread cutting oil at...

My shop is a bit larger, ~750 sq ft, but I don't bother with barriers to keep things separated. However the metalworking and woodworking...