Recent content by glennm

A fun project would be upgrading a used golf cart with a lift kit, off road tires, etc. I bought a 1990 club cart last year for $500 that needed some work and it was a lot of fun. I didn’t get too deep into it since we keep it in Florida and I don’t have a lot of tools down there but, it would...

I have one like that but it has a leak in the tank. I’m not sure if I can get a tank?

“How big is the Johnson (which looks good!)?” Not a question I wood have asked? We are sitting in snow and cold so not much happening at our mill right now. We did cut up a bunch of quarter sawn ash for projects next year.

That’s a great idea ! How much wood can it hold and does it seem to be working well? I could use a small finishing kiln as well. All our wood is stacked outside covered and should be “seasoned” a bit before use

We use them on a BX23 to put logs on the sawmill. They work quite well but i doubt we are no way near that weight. I am guessing maybe 600-800 lbs tops with this little tractor. They are very handy to have for other things as well.

Looks like that worked out well for you

Mine fit nicely together between the joists in my shed. They are the right width and you can stack 8 or 10 in the space of a 2x6 wall. i have a piece of poly pipe that slips in a couple of pipe mounts to keep them from falling out. They are mounted high on the wall and sit on a piece of...

I would make a base for it but that is up to what you like. I always feel if someone is willing to do all the work on the table top the job should continue with the base, but I do know other options are popular

Looks great so far !

To answer a few questions, we only needed to do this to replace the backflow valve and fittings The original galvanized fitting sprung a leak and flooded a section of the basement. The pipe to the barn is plastic and it is buried about 6 ft down so, putting a “t” in outside the house would...

There is a lot of water in the line and a backflow valve installed. No drain in the basement so if I open the line it will be a big mess that’s hard to control. I have a shutoff but it is on the pump side of the backflow valve.

I have a 1 1/2” waterline that runs uphill about 15 ft to a barn about 400 ‘ away. I need to drain it, can I push it uphill with a compressor? There is no option for a drain on the downhill side.

I have used and love Rubio Monocoat. I use the pure version and have been very happy with it. It does leave kind of a satin smooth finish but I this it is perfect for live edge tables. It won’t dull the epoxy, the difficult part is polishing the epoxy without burnishing the wood. If you’re...

Looks. good so far. Now for the sanding . Did you seal it first? If not it may stain a bit where it ran over the top and you will need to do some extra sanding there. I usually run them through the planer if they fit, if not I have a drum sander that works for larger pieces, this is...

I have never experienced cracks but the added epoxy should just flow into them and seal them up I think? I usually just pour about 1/4” in the river for the first pour and then let that set in to try and seal the bottom of the river, that way if there are any leaks it won’t be much. Looking...