Recent content by GullsGN

  1. G

    Lift Position

    Before you bolt the towers down, stand them up and drive a car or truck between them to make sure you are happy with the position.
  2. G

    My 1st Post For My 4 Post

    You can just throw the flakes at the wall, they will stick to the wet epoxy.
  3. G

    Greg Smith Lifts

    If you are at all mechanically inclined installation is easy. I just finished installing my Atlas 9000BP with no problem. I only needed help with unloading and standing up the towers. And I have 2 artificial hips and steel rods in my back!
  4. G

    Searching for lift with 84" clearance at top lock... am I missing any?

    The Atlas that I just bought raises vehicle to over 86 inches with the truck adapters. 9000BP
  5. G

    Remind me again why I'd spend all this money on a floor...

    I am sorta in th same boat. Lots of garage, little money. I am probably going to use VCT tile. I think the commercial grade is around .60sqft. You can always replace damaged tiles. Use the saved money on protective mats/runners in key areas. Plus I can have that cool checkerboard design.
  6. G

    Lift ?s

    Hi guys, I am new here, from MA. I am just starting my quest for a lift for the garage and I have a few questons. Which do you recommend for 2 post lifts, asymetrical(sp) or not. What is the difference and benefits of one over the other? What are some good brands to look at. Any and all...
  7. G

    New to the group

    Hi Guys, this seems like an awfully nice place to start an addiction. I am looking forward to visiting here often. I have a Buick Grand National that I have owned for 21 years. Its home, until 2 years ago, was the small 1 car garage under my split level home. Nice and cozy, but, to small. About...
Top Bottom