Recent content by GYOGI65

I did the exact same thing on mine remover fascia board and slid 2x8 rafters along side existing trusses matched existing pitch 6/12 and installed matching metal roofing been 14 years no issues other than now building 20 x26 addition on the back with ceiling height enough for a lift never big...

Vinyl j channel works well and easy to work with

Run 150-175 psi but have 1 1/2 lines and 1/2 hose but have an adapter to hook 2 hoses into whip hose .some come off hard, with the bigger stuff volume is as important as pressure .450 to 475 for hub pilot wheels is correct

Figure it to be about 15 below by morning thank god nothing is broke furnace and salamander will get it to 65 in a emergency

Check for a loose neutral in the main panel fi thats good plug the multimetr into an outlet and turn on electric oven or drier might be a bad transformer on the pole fought with niagara mohawk for months with similar issue cost me a fridge and water heater due to low voltage

One that brings a lump in my throat just like long lost nimrods garage love them both

yes they do tilt i have a pair for doing brakes on heavy trucks and busses a pair is cheap and saves my back lots

Saw a show that used a sand blaster with corn might be an optoin i wish my kitchen and living room were empty so i could try it just an option

I should of gone into more detail 26x36 pole building 10ft walls with attic trusses .I am debating adding 14 to 24 ft off back with a side entrance or modifying the rafters for clearance was thinking about setting it up outside til I decide or cold weather comes first I have an slow start...

Just bought a forward 4 post 9,000 lbs 4 post lift have come to the conclusion that I either need to add on or raise the ceiling was wondering if any one has an oppion on setting it on 4 3ftx3ft by 6in slabs as a temporary solution til I can finance and get the time for a major project

I still love Nimrods shop

Sounds like mine but a good part of working in a rural area if i dont know the people coming and going co-worker or my kids do .cant get used to working with thiefs.

The gear in my mac 3/8 flex head rachet stripped its teeth granted the rachet is 20+years old but I haven't seen a Mac dealer in 14 yrs so I purchased the Carlyle version for a replacement will know shortly how it holds up used almost as much as my Ir 231

I am also 48 been in the field for over 30 years (dad had a shop).I work for a school system and am responsible for 30 day inspections,yearly wheel pulls,and six month state inspections all the info is logged into a computer but the computer only gives over due or 30 day warning but with a...

Possible to just punch a hole in the concrete and run straight where it looks good .