Recent content by Hchrist

My guess is that it is a watch or clock spring holding, mounting or winding tool. That's the best I can do. Sent from my Pixel 2 using Tapatalk

Turns out it is a watchmakers tool for installing balance spring screws. Sent from my Pixel 2 using Tapatalk

Must be missing a piece. Slotted head screws. Sent from my Pixel 2 using Tapatalk

This looks like a brad pusher but I'm looking for confirmation. There are no adjustments. The center shaft is spring loaded. When the top is left pushed (the red "button") the Jaws open. In the photo where the jaws are open the center shaft is fully extended so??? Thanks Sent from my Pixel 2...

Finally got it done. I'm looking for info on the table feed trip rod if anyone has this on their model 40. Sent from my Pixel 2 using Tapatalk

Old thread but I figured it's worth a shot. I am trying to remove the quill from my Model 40 and I haven't figured it out yet. Any help on this is appreciated. Thanks

If you polish your tool too much it will grow a toenail on the end of it. Don't ask how I know this [emoji39] Sent from my Pixel 2 using Tapatalk

Got it now. Thanks Galaxy S4, Slimkat If I wasn't married I'd quit fishing :)

I know I'm missing something. Either I don't understand why it DOES work (start) OK (and has been doing so since I converted it) or I don't understand why it shouldn't work. I'm thinking that the head unloader valves unload the pressure inside the cylinder heads so that the pump does indeed see...

I have a Jenny single stage GU pump that I converted to electric from a gasoline engine. When doing so I did some research regarding the unloader. The gas was set up as continuous run and my electric is set up as start/stop. I forget where I got the information but it led me to believe that I...

Sorry folks. It's thee centrifugal switch I'm talking about. I changed the original post to clarify this. Thanks Galaxy S4, Slimkat If I wasn't married I'd quit fishing :)

This would be to replace the centrifugal switch that controls the start capacitor in a 5 hp 23 amp single phase air compressor motor. Anyone replace a centrifugal switch with a potential relay? My switch is done and costs much more than a potential relay. Thanks Galaxy S4, Slimkat If I...

Is this done through a moderator or is it something I can do? Galaxy S4, Slimkat If I wasn't married I'd quit fishing :)

Anyone replace a start switch with a potential relay? My start switch is done and costs much more than a potential relay. Thanks Galaxy S4, Slimkat If I wasn't married I'd quit fishing :)

BOHICA Galaxy S4, Slimkat If I wasn't married I'd quit fishing :)