hellspcangel911's latest activity

I agree with the stands / supports, just not in the way 22george uses them. I've got a pair of "tall" tripod style ones on a jack screw...

Jack stands. I know other guys have pooh poohed it, but l believe in safety first. I put jack stands under all 4 arms of the lift, take...

Thanks everyone for your help and support!

Glad you got it done. It's things like this that you just don't get with cheap off shore products and service after the sale with actual...

Don't you love it when sh*t works out?

IT WORKED! The gap I had under the master cylinder was caused by a mis placed washer. Rather than making a mess bleeding out fluid, I...

I’ll report back when I try it tonight

just to update- I spoke to Mohawk (such great customer service), he pointed out that the base of the master-side ram has a "button" that...

Can't remember how much I bled off. Mine is an old system II only 6,000lb capacity since its for the RX7 and have low ceiling...

Thanks for the response, that would make sense. I bled a few ounces and it didn’t work. How much do you suggest? I tried tapping in the...

Hi all, I finally installed at setup my late 80s System 1 9,000 lift. Many refer to it as a "1 line" as it has only one hydraulic line...

Several people have asked questions about my custom lift install, so I’ll elaborate here. I must first preface this with the disclaimer...

The hydraulic line installation underground was a design choice. Mohawk sells (for a pretty penny) an “underground” hydraulic line kit...

Thanks. It's all run in conduit under the slab and up alongside the posts. I planned the build specifically for this lift. Hydraulic...

I had initially installed a slap switch with the original push button on my Forward lift. I then added a contactor (big relay) later...