Recent content by Hydroman22

Will do! Thanks guys for the great insight and tips...!

domain you may be correct. Now after 3 of the 4 minute cycles of the power vent it will flash green LED 2 times = Pressure Switch Did Not Close within 30 Seconds of Venter motor. The tube from the power vent fan is connected to the (-) side of the pressure switch. I assume that is correct as...

Unit is 3 yrs old. Reznor UDAP 100 was installed for one winter at a local commercial building but was removed because it was undersized (building was uninsulated). It sat for about 1.5 yrs before I got it. So I assume I have no warranty. Gas co. swapped out regulator at the house to up my...

OK, I jumped the R and W1 and it powers the vent, short 3' run horizontal out side wall but no noise from igniter. The LED flashes Green fast, manual indicates: Control Status - Green LED Codes Steady ON .......Normal Operation, No call for heat Fast Flash ........Normal Operation, Call for...

That's what I tried still didn't want to light. The power draft fan kicks on but the igniter doesn't click and it doesn't light. Maybe need to bleed my 125 ft of gas line? Whats the best way to do that?

I just purchased the Honeywell low temp thermostat (CT50K) for my Reznor UDAP 100 natural gas hanging heater. The thermostat is heat only with 2 wire connect. My heater has what appears to be three wires going to the wire panel (R, G and W1) at the back. Can I still use this thermostat? Thanks

I just ran mine. or hired it done. Had to boost the pressure at the meter regulator to 2 psi to make the 150 ft run with adequate pressure. That required additional regulators in the house to drop pressure for appliances. All said and done for about 50 ft of 1/2" copper through the house and...

Today I was working on insulating the south wall of my 30x36 pole shed using 6" by 6' rolled unfaced batts and I stuck my hand down between the vapor barrier (styrofoam weathermate plus) on the inside of the tin and one of the batts that I had installed last night and it was hot in there, maybe...

I just got my order from BR. I went with them based on info I gleaned from this site. For my 30x36 pole building (4.5" slab on grade, w/ 2 inch 25 psi foam) they suggested four loops of 300ft , 1/2" ox barrier pex. Basically a 10" spacing and four equal loops across the building.

So why is the nail facing forward? Looks like he would have had to have been nailing above and behind his head looking down? WTF?:wtf:

Hey guys, been lurking here for awhile gathering ideas for my new garage (30x36). Great site! :bowdown: Posts are supposed to be set next week with any luck. It will have two single stall garage doors (10w x 9h) with 10 ft sidewalls on the post frame building. I found a 20w x 10h used garage...