Recent content by ihscomputers

  1. I

    2400 sq ft, insulated metal building. How mush $$$ to install A/C?

    I have a 40x60x12 insulated steel building with 3 non-insulated roll up doors and two non-insulated man doors in the heart of Georgia. We have had temps in the high 90's and the inside of the shop remains around 75 with 3 each 2 ton Daikin mini split units. I cannot give you the retail cost...
  2. I

    My Rust Bullet Project - 2400 sq ft

    OK, here are my answers to the posted questions: TooMuchHair: Ordered 18 gallons and used 17. One gallon remains to finish the areas near the overhead doors. As previously stated, I think that the roller marks could have been reduced or eliminated if I had taken more time and applied it in...
  3. I

    My Rust Bullet Spread

    Your floor turned out great! :thumbup:
  4. I

    My Rust Bullet Project - 2400 sq ft

    Justin, You probably overlooked the following from my previous post: Now that I am a Rust Bullet "veteran", I can honestly say that I believe that roller size has no effect on the roller marks issue. The bottom line is that I am very happy with the overall result.
  5. I

    My Rust Bullet Project - 2400 sq ft

    Justin, The roller marks were made using the recommended 9" Wooster rollers for the final coat. Therefore, the 18" roller is not the problem, in my opinion. Clearly, it is my fault for working it too quickly. In hindsight, I should have taken more time and worked smaller sections. Each coat...
  6. I

    My Rust Bullet Project - 2400 sq ft

    The final appearance has roller marks but I'm OK with that because I am more interested in the durability, ease of cleanup and being able to quickly find dropped items such as screws. The concrete was poured in late December 2014 and has seen no vehicle traffic except for the boom lift that was...
  7. I

    Rust Bullet, good enough for me

    Floor looks great! :thumbup:
  8. I

    Cost of garage floor coating?

    Spend some time researching this forum and you'll get a rough idea of the costs, albeit from a DIY perspective. You will also become a better informed consumer so that you can make a better, more intelligent purchase decision when you finally choose a flooring contractor.
  9. I

    My Rust Bullet is down!

    ****, Thanks for the detailed report on your RB experience! Your floor looks great based upon the current photos!:thumbup: Questions: 1. Why did you use the 12" roller instead of the 9" Wooster? 2. If you could do it over, would you still use the 12" instead of the 9"? 3. If you were to...
  10. I

    Quartz Double Broadcast Floor

    Amazing!:beer:
See more
Top Bottom