IMC's latest activity

There's Hector again on Winchester Blvd Campbell, CA

Cross-posting this from the current thread in hot deals; thought these part numbers might be helpful: 213-4443 - 1/4" standard SAE 12pt...

BelMetric is an excellent online source.

This place is a bad influence. As for the welding…. I worked with a guy that would say “ A grinder and some paint make a welder...

Yesterday, I made a wrench extender from a piece of garage door opener steel and angle iron. I saw a few on GJ and decided to make one...

It cleaned up really nicely. All drawers had liners, but they are trashed and will be replaced. Very little rust The top needs to be...

You are going to have to post detailed pics to get good answers here. But, if I were you I would start identifying the box. Part number...

OK, so hear me out. Instead of buying six feet of old toolbox, I could get almost sixteen feet of brand new for the same money...

I just posted them in Classified section! https://www.garagejournal.com/forum/threads/aluminum-hex-bit-holder.556020/ Maybe this is...

I buy! How much?

Hey all, I went on a little bit of a side-quest a while back in my efforts to make more room in my toolbox. I posted it in "Show your...

No sales today but when I went to the dentist today to have a couple fillings replaced, my hygienist spotted me and gave me some picks...

I started making a few more of these (first for all my bits... then to gift to friends) in the CNC shed, and then I wanted to experiment...