Recent content by integraoligist

Thanks for the info about Grainger, that should help out a ton. Because the drive motor is going while the trigger is Not being pressed... then stops when it IS, I'm thinking someone wired it to the wrong terminals on the control board? And because it stops/runs when I tap the top of the...

Hi all, We bought a used floor scrubber to try and keep the shop floor clean. Make: Dayton aka Viper Model: 14x831 However we need some help with a few items on it. The scrubber motor works great, the vac works, however we have these 3 issues: Firstly, here is a video of the unit... you can...

Hi all, Installing 2 new garage doors. Each are 10'w x 9' h. Everything is installed and we're in the process of setting the torsion springs. There are 2 springs for each door. I get to 33 quarter turns, test the door and i can raise it but it balances at about 1' off the ground. Way to heavy...

I've seen a home with gloss Balistix used. Within 6 months you could see the skin that it left come off the floor. Any chairs on the floor you could see all the wear from the feet... it was not good. I'm not sure which version of Balistix the contractor used but we were not a fan of it.

Hi all, Here are specs of the project. New Residential home, integral color concrete slab. 200g wet polished > applied Densifier > 400 wet polished > applied Densifier ? 400 dry polished. Has a beautiful semi gloss finish, however need to better protect it from stains throughout the home. The...