Recent content by J_E_F_F

I have an LS MT240 and it's been pretty good. It really depends on your property. With the 40hp, I have to deal with emissions (DPF) and I've had what I feel are excessive regens, but the tractor has done everything I've asked of it. 2k+ lift capacity, front hydraulic auger, lane shark, grapple...

We recently took a lightning strike that killed all my garage door openers. I had liftmasters (3280M) from 2010. I replaced them with wall mount Genie openers which are pretty cool, but I have an issue. I use some old discontinued (also from 2010) liftmaster laser parking assists, and they are...

thanks for the suggestions

some pretty detailed into on the ryobi info here, click SEE MORE on the top review https://www.amazon.com/ask/questions/Tx17YLWB4NK8RKQ/ref=ask_dp_dpmw_al_hza

I have new Ryobi brushless impact drivers. The old ones, had a magnet built into the lower area where the battery connects, that space is now used by an LED and a mode selector. I miss having a place to hold screws on the tool. I was wondering if adding magnets to the side motor housing would...

Same lol The open/box wrenches must be 30+ years old by now. The Flare, maybe 15+

@mogandave Seemed to work out well, thanks. Not sure if a new full roll will fit, but a lot sure will. I grabbed a couple 9" reels from basspro https://www.basspro.com/shop/en/114822 before after

that might fit the bill, thanks. I ordered one to try. Hoping it holds quite a bit, as mason string is a lot thicker than most fishing line.

we use mason string now and then for setting up projects around our property, and we try to reuse it whenever possible. I can't rewind it well on the original tube, I've used sticks, and a few other things, but my wife is now vetoing all my current and past ideas. I've even tried the ones that...

some electrical tape around the outside of the joint, might be just enough resistance to stop them from separating over time. I have 60+ of those same style lights, and all but 3 are run with cords between, but of those 3 with the solid joint connector between I have also had it come apart. The...

What's the factory fuse value for that headlight circuit?

current/amps yeah, that's the main thing. 16ga should be good for 13a. Like a chain, the weakest point of the circuit will cause the issue. The switch is "probably" a 20a switch, you can probably pop it out and see the model number and pop it into google to see the specs. One of the reviews on...

I put 2 of those exact same Nilight 4" LED bulbs on the back of my tractor (put a 20" front facing on the ROPS.) I just went and put a meter on them and the little ones draw 1.25a each, so 2.5a per pair. Since you are already running LEDs headlights, you probably have plenty of circuit capacity...

Same here, the lines blur together, I can make out the numbers.

20 years working in electronics, retired and finally decided to buy my own, had it a couple months, really helpful, and much better than the ones that have 2 clips that just slide on a single bar. https://www.amazon.com/dp/B07MDKXNPC/?tag=atomicindus08-20