Recent content by jbass350z

Without going into detail, I need to finish my 3 car garage floor in sections (1 car space at a time). I have the large rounded over contraction joints in the concrete, so I was planning on stopping at each joint (not filling them). I would allow each section to cure before I move onto the next...

concrete is about 7 years old

I live in the desert, yet I seem to have signs of water seeping through the concrete. Is that what is going on in the attached images?. Moonsoons do hit us pretty hard once a year. If it is water stains, what are my options here? I was wanting to lay down Hellfire or Polyurea. Second...

Can you comment about my other question ? There is a 4inch tall lip around the entire perimeter that was painted by the home builder. I have no idea what it was painted with, but I want to coat up that lip as well. I plan to etch the floor, but what do I need to do about the paint?

I have a couple questions. I have a 680sqft space i want to coat. There is a 4inch tall lip around the entire perimeter that was painted by the home builder. I have no idea what it was painted with, but I want to coat up that lip as well. I plan to etch the floor, but what do I need to do about...

I wish I had never opened this thread.

I am finishing out my shop cabinet build and looking for some durable paint. I built a router table cart a few years ago and sprayed it with BM Advance (cabinet grade paint). It looks terrible now with chips all over it. Should I be looking for a lacquer or epoxy based paint? What other options...

I have a 3 car garage that is mostly full, so I am looking for ways to epoxy my floor in sections. My first step was to get it clean so I power washed one of the areas. It has been almost 2 months and the concrete still shows signs of being wet. The power washing didnt really clean it as well as...

How are you guys ordering these if they are out of stock everywhere?

These look great. Are they out of stock everywhere?

I am wondering if anyone here has found a way to make these type of shelves for cheaper than just buying them from Uline? http://www.uline.com/BL_3867/Wide-Span-Storage-Racks-Particle-Board These fit my needs perfectly, but I am thinking it could be done cheaper. I have seen them advertised...

I dont think it is that high. A house I looked at purchasing recently had the entire floor done this way ( office, living room, hallway, kitchen, bathrooms, etc..) There is no way they paid that much for it (based on the cost of the house)

Ok I have read this entire thread and this is something I am looking to do sometime this year. I have one big question that nobody else has asked: How do you know you are not going to tear into something when you rip out a chunk of your garage floor? More specifically how do you know there...

Thanks for the link. I am looking at this as an option in the near future. What is the typical cost for something like this? I havnt looked into quotes yet, but I am guessing 5k ish ?