Recent content by JBAUTO

How did this stuff hold up ? Im gonna be doing my garage with same stuff but worried lol

Hey guys so i ended up going with the SRP400 its good for 40psi and has a water absorption of 2% and R9.4. The price of the 30psi XPS was $48 a sheet vs the $24 for the EPS. The company is telling me that EPS SRP200 which has a 16psi compression under the main floor will be more then enough for...

Hey guys I’ve done some homework I came up with styrorail 2” SRP200 is EPS and has a compression rating of 16psi and water absorption of 4% per volume. I’m building a slab on grade ! I’m doing 2 layers of 6mil poly of the compacted grad a gravel then 2” of the EPS then the concrete ! I see...

interesting build plus fellow ontarian subbed

nice take more pics !

nice build subscribing

just to report back. I used a titan 12kw and a groundfos circ pump in my mechanical room. Now my garage doors are still wood and i keep it at 55 all day long and its costing me about $100-140 more per month to operate.

Hey guys old post but i ended up using the power sprayer for all the corners for 12" basicly on each side. I used a warner manual pump roller. I must say the power sprayer did nice work as long as you kept going. If you stop for a few min just whipe the nozzle and quick blip of the trigger in...

Everyone says water is ok but if you ever go Away say spur of the moment for 3-5 days and your system fails and the slab freezes you can kiss heating your garage up with your in floor heating again you will have to remove your slab and redo it. So for the 30 bucks you need to Spend slap some...

Just for a side note I have a 24x 24 garage with R12 walls and R50 ceiling and wood garage doors I'm running a 220v construction heater and I'm keeping the garage at 62-63deg f and I can work in a t shirt and the temps outside have been 18-25 deg f and that's my only heat spure and I'm using...

I've done this on two houses. You can run a 6" duct with a booster fan and a hut off valve electric or what not. Problem is you are pumping hot air with no circulation due to no return duct. Running a return duct into the furnace to house works but if you paint start a car or any chemical it...

I've been looking at a Titan n120 I can fit it On a 60amp breaker.

Well i guess im gonna give it a try. Would i be better to run a mixing valve with this setup ?

Hey guys I've searched and all post were 2-4 years old and based on 1980 use age I have to paint my 24x24 garage and I have 8 light pockets and painting with a roller and brush will be a pain in the ***. Wanted to know if any of you guys have had good results with the Wagner wideshot extreme...

What furnace you got ? Take a pic of the board