Recent content by jeffgrice

Greetings, Need your heating advice... I have an attached 1000' garage with 10' ceiling that in the coldest days of winter stays 40 degrees without heat. I am looking for a 240v heater (wall/ceiling mount) to warm the area when washing the car, working on projects, etc. Basically just when...

WOW - thank you! Count me IN!!! Happy Holidays!! Jeff

It is a Superformance Daytona Cobra

Greetings. I have a threaded hole on my alum transmission where the slave cylinder mounts that is stripped. So I have been researching helicoil. I can access the hole with about 3-4 inches of working room (without removing the trans) before I hit a frame rail. I have read conflicting reports...

Greetings, Came across this floor: https://www.elitegaragefloors.com/wood-grain-tiles-lvt/ I like the wood look but my major question is has anyone installed this brand of tile in their garage and how has it held up? I am concerned about durability and what happens when tires are turned from...

Greetings Jorgen, I have a charity opportunity to chat with you about. Would you please drop me a note to [email protected] so I can write you directly. Many thanks! Jeff

Nice - thank you! Jeff

Thanks everyone for your advice. I connected with an Electrician who has done Tesla stations and we met this week. He has a good plan to get the proper wire from one end of our tri-level to waaaaaaay on the other side to the garage. Take care, Jeff

Thanks everyone for your ideas and encouragement! Jeff

Hi Walkers! I have a tri-level and the service is on the opposite side of the garage. BUT...there is a conduit going from the panel, outside and into the garage at the opposite end of the house. Why you may ask? The original garage was remodeled to be part of the house and I added a new...

Hey Gang, I am planning to purchase a Tesla. But I think getting 240 into my garage will be tough as the panel is on the opposite side of the house. I read about these units https://www.quick220.com/ that combine 2 120 plugs to make 240. Does anyone have experience with these or an opinion...

Re: Is sheet vinyl ok to mput on a garage floor? I am also interested in feedback on the questions you asked. I have a hard time understanding how a sheet floor would not buckle when turning the tires while not moving. Looking forward to the answers. Thanks. Jeff

I just went through this ... Need to find out the product that was used and then contact the mfg to determine how to strip. Otherwise you could ruin the base floor and poly coating. The product we used was Rejuvinate. OMG what a mess. Our floor was perfect and my wife didn't realize it was...

This is a great analysis - thank you. Question. I was under the impression that GarageDeck is made by RaceDeck and the major difference is GarageDeck is not quite as strong as RaceDeck but more than adequate for residential use. Is this true...or was I dreaming again? Thanks! Jeff

Super - thank you!! Jeff