Recent content by JHAUK

40wt amsoil compressor oil. 1 oil all temp. Change once a year. No worries.

The 93652 has a cast iron hydraulic block on the newer ones. Not as good as the machined steel block version.(i have run into air pockets while machining valve seats). The 4 ton is a good jack, but talk him down so you can pay one of your local jack shops to rebuild and certify it. The no jack...

Ok so to clear things up a bit. First overload protection on the motor does not protect the contacts on the pressure switch from welding themselves together when not 20-25 amps are run through them, but more like 60-100 amps on start up. There just isn't enough metal there to withstand the heat...

40 yrs of jack repair. Tonage should be in the 4-7 ton range. Lifts 1 side of a forklift to work on tires.

10w oil is for very frigid conditions, and if you forget to change oil come spring you will be looking for a new compressor. 40wt amsoil is what you want.

Ok to buy a major overhaul kit including valves,rings,bearings bushings, seals, gaskets and filter elements you're looking at $1161. Plus freight, minor over haul kit is $671.00. Main diff is minor comes with valve repair kit instead of replacements. New 707 is $2924. Whole unit is $6900-8100...

In order to pull bearings on a t30 you have to pull jugs and rods. The crank is a 2 piece overhung style crank. Do not seperate two pieces of crank.

Amsoil 40 wt synthetic compressor oil. No multi grades period. 30 wt nondetergent is fine if you can't find amsoil.

110 plus 110 does not always equal 220. Make sure you are not pulling from 2 110 legs instead of the 220 bar. If you are on 220 you will have 1 breaker not 2. Safety hazzard to only break one side.

What you ia a old Emglo made in Johnstown, pa.The model is "k". and parts are still available. The company changed names to Jenny a couple years ago. Weak spot is the valves, provided unit was not run w/o oil. Tank can be tested with a water pump to a min. of 300 psi. Water not air!

Forklift jack.