Recent content by Jogyver62

More photos

Just finished the install of a new motor and trans in my 35 Ford sedan.

Trailer jack

My Wilton drill press table is so heavy to raise and lower. So I installed a boat trailer screw jack to aid in lifting that heavy monster. Work smarter not harder.

Can you post a photo?

Yes I did

I have a pair of old usa made .

Built a plenum for my neighbors cooking vent hood,

I had a few old copper buss bars hanging around. So I cut them up for cleco bridges. They work great. Plus you can weld right over them. The welds won’t fuse to copper. The other tool is a combination cleco / harbor junk sheet metal bridge

I’m running 600# springs on my 16’w x 7’T composite door with windows. It’s best to call A reputable garage door company.

For the front calipers If it’s not a composite piston, I usually grab my large channel lock pliers and squeeze the pistons back in place. Duel pistons you work intermittently on each. Rear calipers screw type , I made a pinned socket that fits my air rachet.

The oxide film (rust) is cause by oxygen and water(moisture). It will start and stop creating layers went water and oxygen is present. When you eliminate one of the contributors it will stop the rust. Coatings are the number one protector. Clean off the rust scale and grease. Paint it with clear...

Been there with a w 2002 TJ

Added a cantilever platform for the plasma cutter and side grinder holders.

This is the cart I built to hold everything. Tig, MiG ,plasma and bottles.