Recent content by johnasosajr

Here goes, I am replacing a clutch in a 2008 Chevy Aveo I am going to change the transmission fluid while I have the ****** out it calls for 75W 90 GL3 fear oil I can’t find it anywhere except the dealer for almost 30 dollars a quart can I use 75W 90 GL4?

How is the 802 does it work pretty well with domestic vehicles and does it give you code tips like reported fixes?

Thanks I found a modis with the lab scope but they quit doing updates for that too it seems like the only ones that are worth getting that are snap on you gotta spend 3-5 grand on looks like I'll have to get the Autel MD 802 All systems until I can afford the maxisys 908P

Any one familiar with the older souls eesc310? I'm considering buying and curious if anyone has any knowledge of them like does it still have bidirectional controls because I would prefer to get one that does over the Autel MD 802 or 808 pro

I am contemplating buying a snap on modis that hasn't been updated in a couple years will I have to pay for every year or just the current update and does anyone know what the update costs?

What's the best obd2 scanner for all makes and models around 200 any suggestions?

I found an older 18 volt ryobi drill worked fine just had to buy a charger and had it for 3 1/2 years

Sorry I mainly am working on GM, Ford, Toyota, and Honda usually 2010 or later models I need something that is going to work well enough to get me through until I can get a bidirectional scanner

I am looking to buy a scanner and narrowed it down to the bluedriver and actron cp9690 any suggestions on which would be a better buy

If I were you I'd look into getting an oxy acetalyne torch

I know they make a press like the one you can rent from auto zone you use a ratchet or impact on I was just wondering if anyone had something like that I don't really have a whole lot of room for a big press like that at this time

Front bearing on a chevy Aveo I just figure it might be worth having I work on all kinds of vehicles

Does that have to be hooked up to a compressor

Check out the northern star 60 gallon

Hey everyone, I'm looking for advice on a cheap wheel bearing press I can use to press an old bearing out and new one. I see a bunch on line for under 100 if anyone has ordered one and could share a link and around what you paid it would be greatly appreciated