Recent content by Johnny A

Good morning everyone thank you very much for replying to my post. I appreciate it. LOW1 solved the mystery - thanks again

Thank you!!!!

Hello everyone, I discovered this tool and an old toolbox that I got at a recent Yardsale. At first I thought it was a masonry tool and then my buddy came over and said it’s some sort of carpentry tool. Any help would be appreciated thank you.

Looking to purchase an Accurate Tire Gauge. Any advice will be appreciated. Looking for a dial style- under $50.00 Thanks all - happy new year

Hi All, I'm looking for a set of ramps that will have the most clearance. I heard some ramps sold raise the front of the car 14 inches. I want drive up ramps that will allow me enough room under the front of the car. Any advice will be appreciated. Thanks in advance.

https://www.amazon.com/dp/B00X9YUW70/?tag=atomicindus08-20 What have you guys used these for? :):):):):):):):):)

Thanks guys. I appreciate the advice. Will head down to Home Depot & see what closeouts they have on carpets ����

It’s a Merc 4.6 factory height

Hi Guys , I have a seasonal vehicle & wanted to put down an indoor/outdoor carpet in the garage. Just to keep the concrete moisture down ( mostiure barrier). My question is, do you think that the excessive heat from the catalytic converters would ignite any type of mat/carpet? I thought nothing...

Hi All, I was talking to a buddy that is the go to guy when **** hits the fan. Last winter he came by & showed me his winter survival kit in his trunk. He has: JNC 660 Jump Pack Old 1960's Small Military folding Shovel/pick An aluminum shovel Heavy Duty Snow Broom Triangle...

Another question: I have a few oven racks from my old range. Any ideas to repurpose them?

Update: I bought a cookie sheet/ metal & bent it to fit. I will post a pic this week Thanks guys!!

Guys, Thanks for taking the time to help me out. Time for me to go into my scrap pile & make it work.

Hi Guys, Need advice/ideas from you. I used my grinder & had an issue with a piece of metal that went behind my grinder & started to burn a hole in some plastic container. Have any of you built a barrier to go behind the grinder to prevent sparks/hot metal to shoot a distance? I figured maybe...

I would use it for Brackets/ Fabrication/ nothing thickest than 1/8 inch. I have a plasma cutter for larger pieces.