Recent content by jsantoro

Count me in

Most of my gas tanks are coated with POR15 (Redkote works well also), this particular one is clean as a whistle. It's just varnish and gum from the **** fuel. The filters look bad after a few months also. I would agree it's fine if you drive them once a week or so and run fuel through them. If...

For those of us with older motorcycles Ethanol has been a disaster. This is an Amal float bowl. The first pic it was just ultrasonically cleaned the second picture after 5 months of 10%ethanol and endless cleaning of idle passages in between. I have recently found an ethanol free gas station...

+ me too. Just stumbled onto this thread and want one also.

Ultrasonic cleaners do a good job on carb parts. This slow jet was used on tons of Keihin carbs from the 80's on. As Showkey stated it's caused by Ethanol and the **** gas in general. The rest of the carb is probably gummed up as well.

Personally a thin walled propane tank for a gas grill scares me more than my O/A tanks. Use common sense, keep then chained up, and read up on how to use them and safety practices. There is very little you can't do with O/A, very handy. Regards, Jim

I feel your pain. Have 24X20 garage, a car, 2 bikes and usually 1 project at a time. Lately I get in the mood to work on the Triumph project, go in the garage and spens an hour moving wifes **** out of the way, get pissed off and leave. I have not gotten anything done in 6 months. May have to...

Back up to $29.99 as og noon today. Jim

Hi, Does anyone here use one on their blast cabinet? Seems to me it's just a container to hold the soda since you use your existing siphon gun. Is there anything special about it? Regards, Jim

Here's a float bowl with 15 years of crud. about an 10 cycles in the HF ultrasonic.

I needed another drill like a hole in the head but there was this Skil 2414 smaller size drill marked own to $24.00 from $79. Only a 12V Lion but what the heck. Jim

Did you get the square dies from HF also? I've been waiting for a sale for the roller. Jim

What I'd really love is one for the older British threads, CEI BSF etc.

Hi, I'm in Charlotte. PM me what you want for it. Thanks, Jim

Check the freight charges. $977 to Charlotte!!!