Recent content by Jslys13

Really? When I googled the model number I couldn't find much. I'll try again

Hello I recently pick up an airco welder. Can anyone point me in the right direction on an operating manual. Any help would be greatly appreciated. Photos attached.

That would leave the top open. The instructions are horrible that came with them.

I recently purchased lights for my garage, also purchased a surface mount bracket. I just want to make sure I'm doing this right. Do I screw the mounting backing to a truss or do I mount the bracket to a ceiling box? Thanks

Cleaned the needle and where the needle seats real good one more time and that seemed to be problem. Thanks for the help.

Pulled it off and it does float.

Never even thought about that. Let me try that. Thanks.

I have an older Yamaha generator. When I turn the fuel on it leaks fuel in side the carb, like the float isn't working. I took the bowl off and hold the float up and turn the fuel on and no fuel comes in. I put the bowl back on and it leaks. What am I doing wrong?

Thank you.

Thank you. I just liked that they dont require a separate bracket to serface mount vs the ones your recommended for me from bees lighting. Is there a difference in quality?

Not trying to hijack your thread but would that plt fixture work in a 32x40x13.5?

Thanks for the help

Indoor. Pole barn.

Hello I'm getting ready to run my outlets. Some of the outlets fall on the treated 6x6 posts. My question is, are the nails that come with the box galvanized? I cant find an answer. If not What's the best way to attach the boxes to the treated posts? Thanks.

Thanks for all your help.