Recent content by JTB

ill do, just ordered the stat but got a slightly better programmable unit. Should be here next week. Cheers.

Tommy, reading the info below it looks like you can setup an automatic 24 hr sequence that would not need manual input? Single programming mode The Single programming mode, which is associated with the Night mode timer, allows alternating between the Day/Night modes and the two corresponding...

Found one, I think. Stelpro STE402NP, 3F to 86F should do the trick. Night setting also so can reduce setting overnight.

Sounds like a good reason, may be I can re-calibrate my stat.....I have an electronics background so may be that is the only way to go, custom stat!!

I have found a few that go down to 40F, so may be that is the limit? Thanks.

I currently have a LUX ELV4 stat controlling my SIS 75KBtu radiant heater. All works well but burning through the propane too fast. The ELV4 has a 5/2 program scheme but the minimum temperature is 45F so the barn is maintained at this temperature all the time. I want to try and set a sequence...

thanks Chris, perfect!! John

Thanks Chris, that is much appreciated!! I'll send you a PM with my contact info. Cheers, John.

Seems Masterhand are no longer sold by TSC and my tool chest needs new roller guides. Anyone have any thoughts and who may supply new spares? I tried TSC but not too helpful unfortunately. John

Thanks guys, I'll follow up your suggestions.

Recently installed Sunstar SIS75K propane heater in my 30'*40' barn. Fully insulated and holds a toasty 45F heat even with extremely low temperatures here in MI. But I have an intermittent issue where the heater does not light. The draft inducing motor runs but no burn. Talked to the tech...

It's done!! After 6 months HARD work the barn is finished -

Thanks brewchief, appreciate your reply. John

No one? Did I ask stupid questions?

Firstly, sorry for the long post!! Getting ready for winter, barn insulation progressing well, ceiling will also get fiberglass and liners, same as the walls. Now time to plan the Sunstar install. Pole barn is 40'*30' and I will be going with a propane 75K SIS unit along the 40' wall mounted at...