Recent content by kcinnick

I have the dewalt 20v, that thing is insanely useful. I have used it from cutting trim, to cutting holes in the dash in my boat where I couldn't get a traditional saw to cutting locks off. Oh, and I use it as a sander to get to areas my random orbital can't get. Cutting bolts.. if I sit here...

Only reason I was worried about using the fence was that the fence can move on a RAS! I think I am over that, I used this saw today for the first time, OMG is it so much better than a miter saw. I will still use the miter saw for quick 45's but and straight cut is goin on the RAS. I might...

I want to replace the top on a Ridgied RAS I just picked up. It has the original MDF top and it has gotten wet in places and that is just no good. The top is 1" and comes in 3 pieces plus a 3/4" board for a fence. I honestly don't know enough about the saw to know why you need the 3 table top...

Is it possible to put a pass through panel with a main breaker before my current home panel and then run power from the pass through to a new shop. I have a 200a panel, and I only have one spot left for a 220-240v breaker and I can only get 60a of 220 to the shop, I want/need more than that...

I just looked up the permit requirements, people can't really be doing what they ask for with all the structures I see around town. Any accessory structure over 120sf must have everything done for it just like building a house, including a survey. The drop line to my house goes right OVER...

City. I have an overhead line, the power line for the neighborhood runs through my back neighbors yard, reason for the large build line.

I am looking to build a detached garage at the end of my driveway, I have room for about 24' deep and about 30' wide. I have much more room in the back, but there is some silly 25ft build line. I was wanting a two car door on the left (when looking at the Garage) and a regular entry door or...