Recent content by kiotick25

Thanks for the responses. I'll start off spacing equally 4 ceiling fans on a switched timer to come on in the AM for 3 hours when the condensate has a chance to occur. If that doesn't take care of it then I'll transition to phase two and install two 16" gable exhaust fans.

Shawn, The mold does wipe away after spraying the metal with a mix of bleach/water using a garden sprayer. Which is good, just not something as an annual project I want to look forward to. I painted (sprayed) the entire interior of the building with white roof paint mixed in with a radiant...

Here are some simplistic drawings of the two examples.

It has been a while since I have been on this forum. I have run into a problem with my workshop. I'm developing mold on the ceiling at the interior eaves of the bldg. This workshop is a basically a non-insulation sealed box. The condensation between the exterior and interior of the bldg is...

Hello NP Carling, My building is similar to height as yours 14'5 at eaves but 20 at the top of the A frame in an open steel truss design. I'm considering using these fixtures below at home depot. I viewed the ones you attached in the prior post and also viewed them in person at home depot, I...

Last month I completed painting the entire interior of my garage 30x36x14.5. Id say about 15hrs total using an airless paint sprayer. I used an exterior metal roof paint from Lowes - BlackJack roofgaurd 7000 in white $75 per 5gal bucket. It is an elostomeric paint so supposed to stretch and...

I have a 30x36 from Miracle Truss, not sure if any of my plans or the installation manual would help? I had to hire a 3rd party engineer to review and update planned building schematics from Miracle Truss to then give to the county for approval [ mainly for snow and wind load ]. My assumption...

Hello I have a 30x36 garage I put up several years ago and have used the building for odds and ends. Now I'm looking to utilize it a bit more and finish the project with some paint, lighting, electrical etc. I'm looking to paint the walls as the picure shows with a coat of primer and then a...