Recent content by Koehler87

Sounds good. Thank you, for the replies.

Would it be okay to use a 80 grit nylon wheel? I have a ton of chips so its not entirely flat. Thats why I'm asking.

used a brush in three spots while laying topcoat it bubbled. Aliphatic urethane. Will it hurt the coating? How can I remedy?

Armorgarage epoxy chip. Manufacturer state 55 is the minimum temperature.

I tried couple different vacuums, stuff was stuck. Here's a screen shot of my weather. Supposed to rain Saturday i know that day is out.

Because i already tried the solvent wipe the pores were so full of dust. It made the floor feel Smooth. After I washed it all the pores were open and floor was rough again.

I'm in a time crunch, need to beat the cold weather in ny area. There was still dust after grinding, power washed got it all off. Ive had two big fans going all night. Now I have a heater and a fan going. Looking to coat at 6 tonight that will be 20 hrs dry time total. Will that be sufficient?

Not looking to get flamed, made a mistake and cannot go back. Long story short, primer color was put down first, then the hardener, they were not mixed together it was layed one on top of the other. Now it is tacking up, should I take everything up? Or give it time to cure and epoxy over...

Yes, its the perimeter expansion. If it cracks along the whole edge, will it cause the floor to fail and peel up?

Alright, never laid epoxy did intensive prep work. Ground the floor with both diamabrushs removal, and prep tool, angle grinder. Filled in all the cracks with epoxy filler. Ground smooth. So here's where the error came in. I sealed the expansion joint all the way around the garage first, with...

I haven't thought about pulling it out. Would it be a better idea to remove? Or leave in and caulk the seam?

I did use a vacuum, i'm going to vacuum one more time before I lay it down. Thank you for your advice kaizen. I'm going to be doing it this coming weekend. And put all those tips in play.

I'm worried because i've never this before, I want it to be correct. Its smooth and gritty, top layer was taken off. I don't want it to fail because I didn't grind properly. What are your thoughts? Thank you.

Hello I'm new here. I'm seeking advice from more experienced individuals. I have been prepping my garage floor. I ground all the edges with a diamond cup wheel. I rented a floor maintainer, and used both heads from diamabrush. I used the removal tool it had paint from before. Then I used the...