Recent content by Leaky88

To answer the question as to who put these 2 T40 6MM Button Head Torx on there in an obscure location: Credit goes to some General Motors Engineer. Why, is beyond me. Replacements run $7 and some change each and apparently they are now HEX head. (Imagine that?) I bought vehicle used, and...

By heat do you mean the Bolt Head and Aluminum Boss it threaded into? Im also curious about “Grip Brand Drivers” and maker of same. Thanks to you and all who responded.

Hello, I’m at a loss. If I’ve posted in wrong Forum I apologize in advance. Im trying to remove subject bolt (there are 2) that holds the Shift Cable Bracket on an “installed” 4L60e Automatic. Bolt is threaded in Aluminum Boss. I’m certain Galvanic Corrosion is alive and well. T40 socket is...

Thanks guys. I am certain I could install one and move installation fee to best quality unit. I just pulled a manual to replace clutch system… laying underneath. Gets old like me. 🙂‍↕️

Wanted one my entire life, and I’m going to get one. There’s a plethora of stuff on line, but I want safety, quality and personal experience if I may. I have a 40 x 60 Pole Barn pictured. It has 6” concrete floor, built circa 2006. Without modifications, I’m limited to sliding doors due to...

A Lift is something I’ve always wanted, and with each day of age, I want one more than ever. :) Sorry, I can’t speak to that brand. I always buy used and my first question is always: “Why are you selling it?” Short of failing health, moving/downsizing, I don’t know why anyone would sell a good...

OK. I’ll rip it out and redo it. Is their particular type of sand I should use?

Thanks

You put it in a crack and it levels by itself without tooling. It’s good for sidewalk joints and filling cracks. Silka is one Brand.

Hi, Previous owner added a Patio and the gap between it and house was filled with some type of Sealant which is failing. I removed the deterioration section and found no Backer-Rod per se. It appears anything within reach was shoved into the gap and an unknown type of Sealant applied. I...

Hi, I have a Trane Heat Pump System. Today, we noticed the increased temperature, and I discovered the Outside Compressor/Fan unit had stopped working. The Air Handlers were still pumping air out of the vents - albeit hot. I had this problem before and learned to keep spare Capacitors on...

Hi, I have a new HF Badlands 12000# winch on my trailer. Wired it up, exactly like the instructions, rechecked wiring and all connections. Below is a picture of the Solenoid inside Control Box Everything is tight. But winch does nothing with either the Tendered Control or the Wireless Remote...

Thanks for the feedback. I started researching the pump saver after seeing it in a quote for new pump. I’m trying to take every precaution and do it right. The electricity doe# go out on occasion. This my 2nd Well. First had 2 pumps replaced, then the 3rd went. I was not there, and though...

Here is link to a Pump Saver listed on Amazon. SymCom PumpSaver Plus Single-Phase, Model 233P, 230V, for 1/3-3HP Pumps https://www.amazon.com/dp/B0176L8L74/?tag=atomicindus08-20

Continuing my education of Well Pumps… Advertising states these are the “bomb” to protect a Well Pump. That said: 1)Does anyone have a Pump Saver? 2)Are they worth the cost? 3)How difficult are they to install? [I’ve done 3 new power panels in renovations.) Any advise would be...