Recent content by Markgyver

PM'd you Scotty

Okay everyone my dad just had is garage slab replaced so now I want to coat it. My father has Lung Cancer so I want to be sure it is a low voc coating. Below is what I am looking for Low VOC 100% solids Full color chip broadcast. Clear Coat. Any recommendations on Low VOC coatings or any...

I have some craftsman organizer

I have a rigid my dad has a fein needless to say I barrow the fein more than i use the rigid

Fyi you cant use a urethane traffic coating on slab on grade. It will eventually fail. If its not on SOG use a urethane caulk like BASF SL2. Install a 4" wide band of primer and detail coat over sealant. prime concrete install your base coat ect.....

My floor and my father-in-laws floor are wearing great both were installed 6 years ago. Im not really happy with the color I chose so I want to redo it and maybe flake it to refusal and clear it.

my local ppg place was unsure of what to put on top so hopefully you will have better luck getting answer. They did not know if the water based clear would work.

I have been wanting to put a clear topcoat on my aquapon 35 coated floor to help lock in the color chips. I was looking at the Aquapon 4700 but not sure if it compatible? Anyone have any input...

1. 2 weeks should be plenty I kept off of mine for a week and it was fine. 2. I would pull of the top right away to allow the masking edge to level out. 3. I use laundy detergent to wash my floor whever it gets dirty. 4. Pull the tape off while it is still wet so the edge can level out. 5. Not...

$80.00/sq' is a great price, here in the denver area they are about $180/sq'

Where did you get the reservoir?

I have been using these bin organizers from Home Depot for my nails, another for screws, I also have one with all my plumbing parts and another with electrical. They are great to take to your work/project area.

Ditto.... If its a moving joint you dont want the sealant bonding to the bottom of the joint use a bond breaker tape or backer rod or even sand. I strongly recomend using the manufactures primer prior to installing the sealant. Also the BASF Sonolastic SL and Skiaflex 2C are available in a self...

I just built a 8'x15' shed with a hip roof to match the house. I looked into the kits and I figured I could buy one for about the same price as I could build one but mine is a hell of a lot better built than one I could buy, I only could go 8'-0" wide due to my lot (Which is why its 8'x15') and...

Shrinkage.... concrete shrinks when it cures