Recent content by marty68

i agree with c96. worth the time and energy. when you go to sell it they may require you to upgrade it. and by then they may REQUIRE it be done by an electrician. here to add more than 2 devices you have to get an electrical permit.... only an electrician can get an electrical permit. new code...

when you heat a building with radiant heat in floor you must keep the building warm. there is a VERY slow recovery time. it maintains a temp extremely well because you are heating that mass of concrete. i would suggest an on demand propane water heater. ste a thermostat to turn on circ. pump...

lots of potential there . i totally understand "refusing to look at" a house with no garage. my last house had a 16 x 24 garage (the largest the city would allow) the house i have now has huge open kitchen, ex wife loved it. and 32 x 46 garage. to answer you question about separate feed for...

in case anyone is following, thanks to Lx460. and his pdf of wiring diagram. i went through all the wiring and testing all the devices. i determined that a 1.5 ohm variable resistor should not go from 1.2 ohm to k ohms to meg ohms. i then spun dial back and forth several times cleaning the...

update. at the rectifier on the right i have 7.36 vdc. the left rectifier. (picture is upside down) which has no dc out.(why rectify if you arent using the dc?.?) i have 34 vdc. if i pull the trigger i get a 7 vdc surge momentarily on the feed to the motor. after the bigger resistor (10 ohm.)...

i checked for voltage at drive motor. none. spun rheostate no change. i need to trace where i am losing it. i feed 12v to drive motor it spins like crazy. whoo hoo deleting craigslist ad. i can fix this thing

there is no tension on rollers right now. and the drive motor does not spin. i put it on clist. for 275. maybe i shold retract ad. getting lots of interest. and do more research to fix it. last time i had trouble with it i was told drive motor wasn't available.

hello gents. i have a miller 35 old machine not "white face" i bought it used 15 years ago i use it very little. at one time it was feeding wire sporaticly. feed motor seemed to have a "dead spot" it would feed then quit then feed then quit. i took motor out looked at it put it back i took guns...