Recent content by miragesmack

  1. M

    Garage resurrection plans-scissor trusts questions.

    Restarting lane after a four year hiatus and a million changes. Will start a thread when the time comes. Still have to tear down the old block garage first. I’m planning a 36 x 34 stick built garage, for on the 36’ wide gable front, 7 or 8/12 pitch roof, to match the house, in a rural...
  2. M

    Mini Split or Propane ceiling uni

    Good lord, is this argument still going on?!? Efficiency in my world, if how much cooling am I getting and for how much cost, including initial cost. Start with your initial cost, then add up your bills every month, which is cheaper? That is efficient. Initial cost puts you behind the eight...
  3. M

    Between 705 & 1200 SQ/FT A new lease on life: 30x40 schoolhouse conversion

    I just noticed your thread. I too have a schoolhouse, but am going a different route with it. I only checked out your first two pages, but mine too was a dump, that I bought to make a woodworking shop out of, since it was old and seemed up for that task. Then I found out it was a school, on...
  4. M

    Need advice from anyone who has raised the height of a block garage

    So I have a concrete block garage, ten blocks high, and I want to raise it. I’m thinking 5 more blocks to get me to where I want to be, maybe 6 blocks, which is 10’ to 10’8” or so. Anything special I should know before I proceed? Any tips? Can I go higher without any other issues? Budget...
  5. M

    Vintage gas pump security

    Although it’s illegal, you can electrify it. Good for kicks anyway. I’ve got the same concern.
  6. M

    Garage Door Decisions

    I’m with the wife, the standard stamped doors do look cheap. I like carriage style doors but there is a cost associated with them.
  7. M

    If anyone wants to tell you POR-15 is...

    Por-15 is all about the prep. About 99% of failures are due to poor prep. Need to acid etch before using on non rusty surfaces. It shouldn’t be used in that area anyway because sunlight experience over will affect it, and a master cylinder sees sunlight.
  8. M

    Stem wall and gwbwral question about garage height quandry

    Thanks for the reply. If I go with block, I'll need at least 5 courses I'm guessing. Trying to get the height up to look compatible with the house height, and to get inside room I need.
  9. M

    Stem wall and gwbwral question about garage height quandry

    Re: Stem wall and general question about garage height quandry Pics included. 1) pic of garage, on slab. 2) pic from across the street, old school house on left. 3) rear side of garage, with door open to go into future attachment for stick built shop. 4) 30 year old picture of school house...
  10. M

    Stem wall and gwbwral question about garage height quandry

    Need advice. Since I haven't figure out pics yet, will over explain the situation. Have looked through site and understand hindge points, but have a stem wall question, and seek general advice. For the record though, this is a budget build, all cash deal, and tearing the whole thing down and...
  11. M

    Hardware storage score!!

    The best part is, you don't have to worry about it since it's not yours. 👍
  12. M

    Harbor freight generators

    Main beef with them is noise. They are LOUD. So in a shop that might be ok, but if it's for a power outage and in a neighborhood, noise is something to think about. I lose power for maybe 10 days a year due to all the trees and it being an old neighborhood. And you can hear the loud ones for sure.
  13. M

    Advice on detached garage orientation

    I prefer the bottom drawing setup. The top alignment looks odd with the garage doors facing away from the house.
  14. M

    Need springs what size?

    Yeah. My bad, I want paying attention to him have torsion springs. My house long predates those suckers.
  15. M

    Need springs what size?

    I redid my springs on my 80 year old wood door. First, springs are color coded, so if it's not too old, there may be a splash of color on the end coils. Second, you don't have to be exact on spring rates, but want to use your best estimate. I went to a garage door installer and got their advice...
Top Bottom