Recent content by Nakashige

Going with a Vinyl Plank Floating Floor not VCT dont have time or want to wax VCT

So I am going to rip it all up and put down Luan is 3/8th enough between to absorb any defects left behind from having the glue and remaining staples I cant find? Assuming I should screw the Luan down verses nail. How important is it that i scrap the glue off the original subfloor?

Have VCT Tiles in my Office they are about 6 years old were put in just as i purchased the house to replace old carpet in a 4 season room. The tiles are currently cracking where the previous owner failed to remove all the carpet staples. what is the best way to handle this situation looking at...

Picked up 2 for 40 ea

paid 2500 for a 16 by 10 insulated commercial Clopay door installed with opener

Older Kawi's are amazing!!!

The bostech 18 g in worcester on clearance rack this morning 3 left

I dont see many SDS being had do people not like the battery ones? I have a Fuel 18 1in that i love to use for concrete drilling and used to install a sump pump basin

I Have a SGX 7500e Subaru, It does not idle down.

Same thing here in mass

Nice looking domo

Soending some time out in the garage today since the heater was installed there are soffit vents. The garage is attached that wood door will be getting framed in and a steel door installed in a different location. Where the hip roof meets there is a gap. Around a half to three quarters of a...

Any suggestions about the roof deck insulation? There is no venting there is no attic space. can i do batts up there or does it have to be foam

Ill look for these in worcester and auburn mass tomorrow

Call Proformance overhead door in ct. They did my 16 by 10 for $2000 with a opener and track replacement