Recent content by nandomart

Not sure. Could you explain how or what I’m looking for at adjusting them? And if possible how they operate?

Purchased 2 used roll up door motors off of marketplace and was wondering if someone could provide some input on how to test these/control wiring. I’ve tried connecting 1 and 3 together and nothing. I’ve tried connecting 2 and 3 together and nothing. if I press on on the motor contractor for...

I’m confused as well, the nameplate is and has been attached to the thread since I started it. Can you not see it?

Thanks guys I appreciate the feedback. It appears that I wasnt doing the right research regarding VFDs and compressors. I went back yesterday and found threads on not using them with compressors. Is that still the consensus? I mostly wanted to use the slow start funtion of the vfd on the...

Changed it. I meant I don’t have three phase. Can you explain to me why I’m going bout this all wrong? From the reading I’ve done there are some benefits of running a vfd on a compressor. Also, I’ve read that a three phase vfd would work for the application I’m considering. From what I under...

Im looking at purchasing a compressor with a 7.5hp 3 phase motor. I dont have three phase at my place, so Instead of buying a single phase motor Im considering a VFD. I found one with the specs below and Im hoping you guys can help decipher if this will work for my application.. Voltage...

well the search continues.... the compressor was trashed...didnt help that it was already in their scrap bin. crank was bent on both motors and the flywheels broken. Offered them 100 for the motors and wouldnt take it. Was firm on 350. Dont get it since I offered more than they would get in...

I am supposed to go look at this this afternoon. However, during some reasearch it appears that these might be 2 r15a pumps. Still a good deal?

Im looking to replace a campbell hausfield 80gallon compressor that the pump died on. The tank is still mint since it was kept indoors all its life and drained while in use and with an automatic drain. I came across a vintage duplex champion compressor that has what appears 2 r30 pumps...

Im stuck between a rock and a hard place on this one guys...can anyone give me some advise here. Is the attic route a better route to take? Fernando

GM not sure i understand your response. The alcove will have sheetrock. Here is a sketch of wha I have http://imageshack.us/photo/my-images/713/unledhzi.png/ The brown are the kitchen side cabinets...the red is the wall of the alvoce behind the cabinet..the blue would be the water heater and...

Hey guys...I have a question regarding the relocation of a water heater in my house. I am still in the remodeling phase of my home. We had the kitchen redone and we had an "alcove" built so that the fridge would be flush with the cabinets. The space behind that alcove is about 3'w and 4' long...

this seems like a good deal can someone confirm? http://www.amazon.com/dp/B000XITE7E/?tag=atomicindus08-20

It can go either way I if I fig it to the truck system I can use a hose connection from a semi. And electronically control it with electrical solenoids. Im sure someone has done this before..was hoping that person was on here lol.

I would actually like to have the trailer drop to the ground complete. Ideally it would allow the loading of a car or 4wheeler with out ramps. I was assuming that it would need a some kind of independent suspension..since the trailers axles wont allow for that to happen.