Recent content by newlywv

I was placing it in the shop using fork lift. It slipped off of one of the forks and laid over on the handle for cross feed. I was lucky that no body was around and got hurt. Thanks, Rich

I found some of the parts, but still need the front taper attachment screw. Rich

Hello everyone, I just purchased a 16" South Bend lathe. Unfortunately, I broke the hand wheel and cross feed screw while getting it in my shop. It has the taper attachment but that part is not hurt. I am needing a hand wheel and nut, large graduated dial, bearings for controlling the back...

count me in again Thanks, Newlywv

I have an all original 56 red and black just like the one in the pics posted. Love these cars.

Well I tried that and they want to sell the replacement motor for $400. Thats why I am asking the Char lynn motor because they are a lot cheaper. Thanks for your quick reply. Rich

I have a century 411 wrecker with the ramsey 8,000 lb. hydraulic winch. It is missing the hydraulic motor and I would like to replace with the proper one. My question is which char lynn model would be the correct one? I have the century part number, but plan on making this into a dual line...

I am into auto repair and restorations and body shop work. I own a 1956 ford fairlane and a 1965 gto tri power. I collect sk tools also. I will be thankful for any gift. Happy holidays to you and your family. Rich

I am thinking a complete booth package is going to be cheapest. Rich

I am needing to replace the lights in my paint booth with explosion proof lights suitable for paint booth use. My question is do I need to replace the entire light fixture? Or is there a housing that will hold regular flourescent lights to make them explosion proof? Where is the best place and...

Yes they have been sold. Thanks

I have one that is the NAPA branded Homak. It is a very good box, well built. It is big and it is heavy. Looks great and the quality is great also. Yes I like it a lot. Rich

I had a bad kickback a few years ago. Piece of red oak hit my safety glasses and gouged out a chunk in front of my eye. The glasses then was pushed against the bone above my eye socket. I seen stars like in cartoons. I have never been hit so hard. I had to go to the emergency room and get some...

Yes I cleaned as per the manual. The pellets over run the burn pot after a few minutes. and the auger motor does stop and start. After cycling through a couple times the light starts flashing. The ignitor is getting hot and trying to light.

Yes, the status light flashes 5 times.