Recent content by nichboy

I had the same thing happen with a Ryobi drum sander, took it to the shop for an estimate. Ended up being a bad Rectifier, $12.00 latter been working like a champ. Might check that if it has one.

I was told consumers can't purchase this stuff or the quantities were to large. Chinmey sweeps were the only ones using it and i don't trust any of them around here.

I may be in the wrong forum but, i was on the roof this weekend and decided to check out the fireplace chimney. Noticed the Mortar Cap was solid but had some cracking in a few places. What can i coat the cap with to seal up the cracks and waterproof the rest. Thanks

This resin your talking about, where can it be purchased at? How is it applied, drying time, attract any dust?

With the different temperature swings in a attic, what is the best product for decking. I currently have 1x8's but they have come loose and started curling.

Ok. Thanks guys, I think i will pass on this purchase.

Eastwoods offers this tool: "Spot weld kit using your mig welder" Has anyone ever used it and how did it work out for you? Thanks

I built 2 sheds 16x12, and 16x16 6 months apart. One I used t-11 and the other I used 4x8 sheets of Hardie board. No comparsion, by far Hardie board looks and has held up better than the T-11.

A guy at work is having trouble with gophers digging under his house and chewing through his pex lines (around here they use concrete slabs) after the 3rd leak (flood) he had all his piping routed through the attic. Its rather common around here.

I have a couple PURDY 2" paint brushes that i on;ly used with latex paint some time back. Evidently i didn't clean them well enough and they've become a little stiff. Is there anyway to restore them back to a usable state.

Yes it is on a slab now. Good idea on the tack strip.

I have a low spot (3'x6') in front of my fireplace, has anyone used a self leveling concrete product they would recommend. I have carpet there now so i would need to put the tack strip back down and relay the carpet. Any installation tips would be appreciated. Thanks

Coors Lite on tap.....

Thanks. Should this stuff be removed before i start welding?

I just bought 10 sticks of 1" tubing yesterday. what is that black coating they apply to the metal (i assume its to prevent rust) that stuff gets everywhere, what should i use to remove it? Thanks