Recent content by Pachuke

Okay Guys here goes I did in fact purchase a xp-10cx. And yes i complained. However Now i have to Eat Crow. Not much of a Man if ya Can not be Humble. I have had problems and most probably complained the most, ya i know **** it up. However, I did tell Joel from Bendpak i would do what i...

Oh i just watched a Video by the way , of a lift that was supposed to be rated at 12,000 lbs, and they lifted a 15,000 lb piece of steel and the carriages buckled. Made in Japan. Certified IN USA. This was a company that actually does test to see if there actually safe top use. I was under the...

So You Guys think this is suspicious. Good nice to know that no one believes every thing that is said,. Now it has been almost 2 years, and many E-mails, someone suggested give them a break and they'll come threw. Well i received a E mail confirming that only after i complained, many many...

All i can say is Next time i think of saving a dime,. Kick me where it hurts. Ill never compromise quality for safety again.

Thanks guys for your response., I am not a UN-reasonable person. All i asked Bendpak was Please come out and look at this lift. They would not even respond to my request. That was 2 weeks after i received Lift. Now its been almost 2 years and a millon E-mail request later, they will not even...

Please Beware, Bendpak lifts are not built in the USA as i was told by a company i purchased one from (BABCO SALES) in British Columbia. It is assembled in USA. Which to me means. Not much since i had to assemble all components here. More like Packaged. I purchased this lift in 2007...

Re: Kinda misleading I would say BS. Your lifts are manufactured in Japan or china. Your own warranty clerk Joel Told me so. So either he's full of it or you are. As well as quality control. Id have a better chance of being thrown in front of a bus. I have cx 10. More headaches than my wife...

Dear Brad. I have a 10 cx and have had nothing but problems . Starting with holes not drilled center to center to 50,thousands pin clearance in arms. Snapping in columns and i have noticed things like arms drooping down at least 3/4 to 1 inch. Not bad for a brand new lift. Contacted Bendpak ...