Recent content by palumbogio

my set up is this compressor located in the attic 5 feet 3/4" pipe down to shop a tee on one side of tee 5 feet pipe back to attic on the bottom side of tee is the drop leg for drain from the attic I have 30' of 3/4" black pipe to the first drop than 20' more of pipe for my second drop each...

Hi Everyone I have few air compressor lubricator personally I prefer use few drops of oil in my tool before use so I was thinking to modify the lubricator ( removing the pick up hose from the ball and close the screw all the way in )and insert silica gel inside the ball so it can be use as...

This is one man show so I cannot cut and weld at the same time

I'm looking to put the box on the cart and run the 35' cord to the wall outlet

Hi! I need help how to wire 2 receptacle together both receptacle are used for a machines ( miller 211 mig and a plasma cutter 50d ) that draw 25 amp My set up is a cart with the plasma and the mig on a double gang receptacle box with one L6-30 and one 6-50r receptacle in attached to 35'...

and this http://www.dontscrapit.com/Georgia-/Construction-/Miller-spoolmate-3545-spoolgun-sga-100-195015-partpic.jpg

I just ordered this

Hi ! Help needed for shop remodeling I have a 24x24x8ft ceiling garage with a divider load bearing wall in the middle I would like to remove a 12ft section of the wall will a 2pc 2x12 header be sufficient for that span of opening? The trusses they run perpendicular to the wall in question above...

Checked voltage in both line and both are hot I hook up the pressure switch to a different 220v source and the compressor vorked as it should I think is the level switch I will make a trip to lowes tomorrow and purchase another one and a new breaker just in case hope this will fix this problem

They read 240v (I meant 120v per cable x 2 ) the breaker is double pole 30 amp

Hi! everyone I need help to diagnose this problem I have a a 5 hp air-compressor 220 v 21 amp in a dedicated breaker connected by 10/2 wire(1 white 1 black and 1 grey wire) with a manual cut off switch by compressor I check for voltage at the switch, pressure switch, and the motor both the...

Hi! My first post here. I want to thank all the member for all the knowledge and information that you guys share. My current project is relocating a 80 gal compressor in my shop attic and replacing the pump for more cfm to be able to media blasting my old pump is a kellog 321 1hp motor my...