Recent content by Pcf782

Yes, they do ****. It's a little too small, so it never lined up correctly.

Thank you

Thank you

I added a box extender to a two gang bell box. The gasket sticks into the box on the left and right side. So, the outlets (and maybe the wires) are touching the gasket. Is this normal? I followed the directions exactly.

Thanks for the info. I'm leaning towards them in the same box, because it would be one less box on the wall.

Thanks for the clarification. I bought a small piece of the tri-color bulk wire at Lowes, and they label it as 12/3 THHN wire, so I've always referred to it that way. But, even that doesn't make sense because it's Black/White/Green. Shouldn't it be 12/2 (do not count the ground?) Anyway, I'm...

Thanks, I'm going to use one run of EMT. Will definitely look better.

I like that idea, would look clean. Thanks

Thank you, I'm trying to figure out what will look best (and I've got some extra receptacles and boxes to use). I did read that some people separate the switch and receptacles into different boxes, but not sure that's a big concern.

I have a 20amp circuit for my garage, with receptacles and lighting on the same circuit. The lighting consists of a single low watt LED fixture at the entrance. I plan to use surface mounted 3/4" EMT conduit with 12/2 THHN wire horizontally across the wall to an octagon box / light fixture...

I have all surface mounted EMT conduit on the interior of my garage. I'm going to transition to PVC outside for the gate power. There is a junction box on the interior wall 3ft from the hole in the wall to the outside. Should I make the EMT to PVC transition at the j box and have a small...

Yes, that is going into the back of the junction box.

I just added some new pics, what do you think? I would rather not have to redo that area. Thanks

Thanks, I will take a look at that.

Okay, thank you very much.