Recent content by phred

4 wheel disc conversion on this pile. I would highly NOT recommend “The Right Stuff” kit. A friend bought this and asked me to help him install it. It doesn’t fit very well and the instructions **** especially since the instructions referenced photos is of a completely different style caliper...

Battery box, battery hold downs, bumper and tool box holder

I’ll play. ECU mount, frame plates, brake line standoffs, more boxing plates and under dash hvac unit stand-off. More to come. I dimple everything.

Seat frame is 90% complete. Still need to design and locate the center console. The hvac system arrived. Got the billet vents becasue they look similar the boze wheels I plan on running. This hvac box is designed to mount on a flat firewall. So I fabbed up a stand-off to hang it on using the...

Been there, done that. It’s amazing how much oily, greasy dirt can accumulate in that crossmember

Outstanding. I bow to you level of skill.

Justin I know you said you did want a mustang 2 style setup. This I my 66 f100 that is being built for pro-touring. There should be matching holes in the frame rails where you can bolt in a removable crossmember like I did here too keep everything in alignment. I used a piece of 2” 120 wall...

A bit more progress this week. A pair of recessed hood hinges arrived, started laying out the seat frame for the recaro seats, finished up the rear housing install with the big wilwood brakes and made patch to cover the antenna hole.

Spent some time assembling the rear. Moser alloy shafts, wilwood 4 piston calipers and rotors with internal parking brake. Moser nodular center section with 3.70 gears with an Eaton trutrac.

Wow it’s been a minute since I updated this thread. I’ve been busy with the truck, making progress. The rear housing is back from the fabricator and I had it powder coated. In the meantime I worked on panels for the doors. The lower panels for the doors were hacked by the PO for speakers...

I lived in Atlanta for 25 years. The termite bond was a must for resale. It was as cheap insurance for me. The house I lived in was 100 years old. Keeping those pests out of the old structure was worth it and knowing the value exterminator was on the hook for repairs.

Shortened the steering column in the pickup by 2.25 inches.

Checked runout on the Bellhousing for my new tremec tkx. It’s out .006, need to get some offset dowel pins. Tremec will not warranty the trans if it’s off more than .005.

NPD has the core supports in stock. I looked last week for one for the pro touring truck I’m building.

Unboxed this