Recent content by Pinski1015

Ditto on Milwaukee, but for masonry work Hilti is the only way to go

Vintage piece from my dads collection. Back when ergonomics weren't on the radar.

Not impressed with their ratchets. Have 3 1/4 ratchets from them, 1 is stiff and 2 have dead spots where it's difficult to spin.

Picked it up at the Flea market for 35$. Would like to know the tooth count and around when it was made and if it's a good buy.

Father sold me a set of 10 Proto "Anti slip design" 6 poin combo wrenches he had laying around for 20$. Set covers 7/16 to 1 inch. The Roll and 1/2 wrench are missing at the moment but he said he would try and find them. Are these wrenches any good? I figured for 20$ I couldn't go wrong either...

Close but these wrenches don't have names

Couple old 90 degree offset wrenches I found with no name. They say "Made in U.S.A" on one side and "Forged Select Steel" on the other.

Here you go.

Now is there any way to date it?

Got it working and together. Thanks everyone. It's way smoother and quieter than before with the lube.

This was just a simple clean and re-lube. Did not disassemble further. Looking at it the pin is stuck to one side, What now? The pawl pin is also not coming out and seems to be stuck.

This really *****. Might call S-K about a rebuild kit tomorrow if I can't get this straightened out.

Still no luck. I have very little play with the switch either way the cap is put on.

Yes.

Did not get to lube it yet. Put selector on and It is still **** and will move very little.