Recent content by rgalbert63

  1. R

    Minisplit installation COST

    Seems high to me. I recently had a 12k btu Fujitsu installed for $3,100. This was reasonable considering online prices for the compressor and condenser were in the $1,600 range. I also recieved $500 back from my State's energy efficiency program to sweeten the deal. Sent from my SCH-I545 using...
  2. R

    Garage Unit Heater Final Install Advice

    Hello, I apologize for the long delay responding: FWIW, I realized after installing the drip leg, which is what NovaVent instructions specified, that I instead should have followed Reznor's instructions which specified that the vent pipe should be angled downward with NO drip leg, allowing any...
  3. R

    Custom Ford Reznor Heater

    This Reznor UDAP 45 was stripped of its factory decals and customized with an OEM Ford emblem and can of Ford Blue engine paint. Looks great with NewAge cabinets, polished concrete floors and a 2006 Tungsten Gray Ford Mustang GT (more pics to follow). Thanks for looking!
  4. R

    Garage Unit Heater Final Install Advice

    Thank you. I should have mentioned that there is a gas shut-off within 6 feet within the black iron pipe and also an electrical cut-off switch.
  5. R

    Garage Unit Heater Final Install Advice

    Greetings, I'm nearly complete with my Reznor UDAP 45 propane unit heater DIY install and would any appreciate comments and opinions on the venting, gas, electrical and thermostat connections shown in the attached photos. The heater has never been started...this will be done by a licensed gas...
  6. R

    Reznor UDAP 45 Thermostat Question

    Greetings, I'm in the process of installing a Reznor UDAP 45 unit heater in my 2-car garage. I plan to use a Honeywell Pro 1000 heat-only, 2-wire t-stat. Before I run the wire, will this t-stat work? It's NOT being powered by a 24 vac transformer... I appreciate any input!! Thank you, --Rob
Top Bottom