Recent content by ringandtip

Thanks for all the input.

Great points. Much appreciated.

Thanks for the reply.

Hello All; Looking for input on relocating my well tank and control from and old building to a new one. The old location may still see some water usage as will the new location but the primary usage point remains unchanged at the end of the run. All existing and new piping is the same size (1...

Thanks. I must have been using the wrong search terms. "propane truck fitment service" did the trick. Much appreciated

Hoping someone out there knows... Getting a propane delivery to a large stationary tank (that's about half full if that matters) approximately what is the delivery rate in GPM (gallons per minute) Is is possible that I'm getting 200 gallons pumped in a little over 3 minutes? Thanks

To revive an old thread.... Walking through the local Ace Hardware today and saw 5 gallon buckets of driveway sealer on sale. Anyone ever try it in tires?

Thanks for the input. Much appreciated.

I've got an old wood frame 4 section overhead door that I'd like to avoid replacing. The wood frame is in good shape but the panels are made out of some sort of fiberboard and are toast. Warped and falling out. My thought was to cut some pieces of something like 1/8" HDF to face the entire...

I was wondering if anyone has had any experience spraying concrete. I have an old spring house with a brick foundation. In addition to most of the mortar being gone from the joints some of the bricks are deteriorated as well. I had a thought that using some method of shooting a loose mix on...

Well, thanks again for the input. I was hoping someone had some experience with SealKrete or a similar product. It dries clear and the manufacturer says it's OK over paint and application would be easier than a total repaint. Don't want to take the chance of applying yet another coat of...

Seems like a lot to me. 2 coats of "masonry" paint. Don't have the cans unfortunately to see exactly what it is. Siding has good overhang at top of block (~3/8) providing a pretty good drip edge. Closed cell foam gasket between top plate and block. Side wall also have the problem (when the...

Thanks for the input. Building is 18 mos old. Mortar joints are perfect. Latex paint (for masonry) 2 coats. I considered using DryLok on the interior but worry that all that moisture would then be trapped in the block. Plus at that point I may as well re-coat the exterior. Similar cost and...

Hi All; Working on finishing a new shop with concrete block walls. The exterior has two coats of paint that was supposed to also seal against moisture. Not so much. During a driving rain, water penetrates the block and mortar joints. Anyone have any experience with sealers that can be used...