Recent content by Roverguyjoe

Okay that’s pretty straight forward thanks! There’s local fuel/oil company in town that delivers to the marinas and you ca go to their physical location to fill up as well.

Would somebody be willing to sketch me a little diagram of grounding for a Fuel trailer? I have a DOT approved aluminum fuel tank that I’m going to put on a small utility trailer so that I can easily get ethanol free fuel in bulk for my plane. Do I just need to ground the fuel tank to the plane...

It’s an old fiberglass single chamber tank with no baffle the access holes are to get access to the inlet and outlet. So you can pump it down all the way from either side. I’m going to dig up the distribution box tomorrow. I guess my main wonder is if was never hooked up would the drain field...

Whoops meant to put this in general discussion not tool thread

40 year old system. My parents were the previous owners from new. Always had a septic issue from early on. Their solution was to just get it pumped every couple years. They always had it pumped from the inlet lid never outlet. I recently had it pumped but out of curiosity I dug up the outlet...

When my dad was building our house in the 80s I remember going to Scotty’s with him to pick up supplies I was 5ish at the time. And I remember in the nail section where you weighed out nails there was a hopper with like maybe like 2in round aluminum discs that were made out of scrap soda/beer...

The felts have it. I guess I’ll just stick with tried and trued. Thanks everyone.

It’s a code requirement

I am closing in a breezeway between my house and detached garage. I went with zip sheathing because it’s a “when I have time to do a little bit project” my next step is exterior cladding I’m probably gonna go with faux dry stacked rock for the bottom half and hardy board or hardy siding for the...

I have a hydraulic line on my Kubota that cracked. I need to cut it back and reflare it. Apparently the lines are 37° flares. I’m looking for a budget flare tool that will do stainless steel at 37°, but they seem to be pretty limited. I’ve looked through here and most people recommend the...

Gracias

Has anyone messed with automating Hayward pool equipment? My parents place has a Hayward vfd pump and a Hayward heat pump heater. I’d like to be able to do some remote control for some set backs on the temperature and run times. Hayward makes an integration device called an omnilogic but it’s...

I have a Champion Model 800 spark plug tester cleaner that my grandfather had and I'm fixing it up to let my flying club use it for maintenance. The push button switch is broken and the sand blasting nozzle has seen better days. Any idea where I can source them?

I have a ridgid wheeled one like mentioned above but I recently got the ridgid battery one that project farm reviewed. I already am deep in the ridgid battery platform so it was an easy choice for me but it’s a great little vac I find my self grabbing it more often than the wheeled one. The...