Recent content by rq375

I used 3/8 sliding T bar / torx socket and hit it with a hammer a couple of times, just support it at the chuck, not the body of the drill.

HF cement mixer + sifter tray for 5 gal bucket

This is specifically why I bought the 6.5 Fuel saw, I've used a worm drive for too many years.

I'm happy with my Williams set

When my father retired after 35 years of working as an electrician at a paper mill he was on his second set of whites. I'm still wearing the Whites I bought in '98

I have the 3 gal hotdog compressor, works fine for nail guns and bike tires, I think i got it on coupon for $40 and its noisy. I also have a 93274 60 gal 2 stage, very good for the price.

You might double check, my pole barn required building, electrical, health, and roadway permits plus additional building and electrical permits for later added mezzanine (WA state)

I put the Rohm on my 2704, problem solved and a much better chuck even if the original didn't wobble.

I have one of these loaded with taps, SAE, NPT, and Metric: https://www.amazon.com/Akro-Mils-10164-Plastic-Storage-Hardware/dp/B000LDH3JC/ref=sr_1_8?ie=UTF8&qid=1534448944&sr=8-8&keywords=akro-mils+10124+24+drawer+plastic+parts+storage

do you reload? throw them in the case tumbler with some walnut shell media.

They come in different sizes, and specific brands fit certain face profiles better than others. Buy local until you know what fits your face.

Tide and a stiff brush.

Festool, now with Lucas electronics...

The notches are to crack the edge of the piece off somewhere other than the score line, and the ball end is to tap on the cut section and shatter then entire pane...

99+ Ford F-250/350 is 8x170, F450/550 is 8x225 until they went 10 lug. "traditional" 8 lug pattern is 8x6.5". You have to measure OD, offset, center bore, and lug bolt circle to be sure.