Recent content by scopx

Will be using the chest freezer type as above, utilizing the 2X insert below door for kegging. The faucet and gas will be mounted thru the 2X also. Nice work Larry 4406. I do most my drinkin' in the garage rather than plumb into the house. Will pull old scuba 20 gal tank out of garage loft...

Supplies: I suppose you mean the actual goods to do the job. There are in smaller communities, free publications such as penny-saver, thrifty nickel, etc that have lots of suppliers of metal roofing materials and trim. A national concern is Mueller's, metal mart to name a couple/ Stay away from...

Quality workmanship, regardless of the fixturing process used. Am open to variety of processes and ideas here.

There are publications by both B&S and aftermarket such as clymer, and haynes. The B&S is the more thorough, however they tend to overlap processes and one must skip from from process to another. Watch the bolt/stud mounting very carefully on Briggs as just enough disparity in lengths to cause...

Just got a periodic email from site that explains in plain english (only way I can understand) some of the principles of hydraulics-and troubleshooting. Its a good read. Hopefully, link will be below. http://hydraulicsupermarket.com/technical.html

Thanks guys for the advise,will say no more. Consider me warned.

I knew this would cause some controversy and get some flack over it. Will post the link or info when find the book. Its at the other place. I have used this for over 3 years and do not expect any OSHA inspectors to show up as it is a private garage, not a going concern. It works for me and...

Would surmise that ABS is being phased out is that there must be something in the composition of the material that does hold up as well as originally planned. Also think it my have some toxic properties not conducive to the human body. In my observation, PVC has tighter tolerance and deeper...

The best source I know is "Brendan Casey". Type his name in search engine. Was able to get on his periodic troubleshooting e-mail list. Can't find link now or would post ref here. He has answers to lot of common fluid problems.

As most of the replies here are recommending a hole saw, could you provide good brand name and inexpensive source for same? Some I have seen online are rather expensive.

I live in less than urban area and have owned this property 9 years. I have checked occasionally on Google maps throughout the years and find they did (GOO)pick up the barn in 2009 aerial shots. And yes, think that more of the local governing (taxing bodies) are using this to find those that...

Thank You Red, will try that source type. Am surprised to get only one response with over 150 views.

My son used to crew on one, and if recall correctly, was called a "sky stallion?" He lamented how pilots enjoyed causing crew to cringe when they would rotate in tight figure 8's (with prop ends close to vertical) while side door(s)? open. He said the "auto-rotate" was adrenaline rush also.

The best publication I have found for my application is titled "Wiring Simplified" which has green and black cover. It does not wade very deep into the technical side (fortunately), and in "plain language" describes requirements. After going over book several times was able to, by myself, run...

If I am not mistaken, the spring loaded switch mech you are installing is the device that switches motor from the start capacitor to the run capacitor. Hey, some electrician help us out here.