Recent content by scratchedup

To bad we can just trash stuff and buy new for cheaper then repair....

Hitachi NP 35A 23ga PIN NAILER This has been sitting on the shelf for several years. Bought new but never used (might be related to the problem). I have started to use it and it worked great for a week or so. Today it just stop driving the pins. Seems like very low pressure. I will not drive at...

Wow... Thanks never heard of that...I did not realize that I needed so much protection!

Milwaulkee compact router 1/4" collet. This thing is pretty new. The problem I'm having is the bits sticking badly in the collet. I've cleaned everything and still sticking... What to do???

all good...really looking more for strain relief ideas...thanks

Any ideas on a simple fix for a worn out rubber coated 120v power cord? Its been great saw but its over 20 years old and it would be nice to have a new HD power cord.

OK thanks...I followed your advice. I just bought this...

The Hilti TE17 I used to borrow was a beast. I kinda want something that is like that...plenty of power. I do not care about newness or cordless...so if I had to say old or cheap I would say cheap but not junk and lots of power. I love newer tools but I just can not justify the cost for sometime...

I am looking a buying a Used (older) rotary hammer drill to buy. Occasionally I have borrowed a Hilti TE 17 that is great but it's no longer available to me. These Hilti's are on eBay for reasonable prices but seems a little risky being very old....thoughts. Also there is a TE 16 ??? Newer TE7...

I have acquired this old tool. It still performs very well however I would like to upgrade the bits. Can someone explain which types of bits it buy and which are interchangeable? The Hilti sites list connection end- TE-C (SDS Plus), TE-Y (SDS Max)...

There are 3 columns for the tap drill size guide. What does "Body Drill" vs Tap Drill" mean? I get the tap drill size but confused as to what the Body Drill term refers to.

Yes...thx I did that. I see why the guy sold me this saw 11 years ago on C list. Its been a good saw but.....

..."I wuld assume you loosen the front and rear trunions where they bolt up tothe table. The holes should be slightly over size to allow a bit of adjustment." I did this and it does move a smidge. Hopefully I will be able to make this work...its crude and slow due to loosen/drift it/measure...

:)

JET- JWTS-10JF Table saw. Per the manual...It appears the blade is not adjustable relative to being parallel to the table guide slots or the fence. Is this accurate? Is there any way to make this adjustment? Thanks