Recent content by seth928

Omp....honestly the feelings are mixed:headscrat....I like what I have accomplished:).....I do wish I did a few things differently:wtf:....and its still not completed:dunno:.....and more than likely I will be leaving it behind, we are probably going to relocate in 2-3 yrs:confused: .....but I...

Your build is very nice:thumbup: I was going to do something similar with hardware from a company that pre-frabricated the brackets but I chose this route instead....also saved me quite a few bucks!! I have way beyond exceeded my initial budget....sooo every little bit helps:headscrat

Thank You, I plan to have heat for sure, probably a Modine hanging heater...I also plan to insulate at least the roof and loft. I don't like the idea of covering it up either so I going to barn board over the insulation.:)

Thank You :beer: The landing isn't completed yet haha...I have to tie it into my collar ties and add a railing...hard to believe but the way its mounted now it doesn't move at all, its through bolted through the steel I Beam and also 3/8 by 6" angle iron on the 4 corners...but I agree it looks...

Lyle you can see my build here http://www.garagejournal.com/forum/showthread.php?t=135752 I look forward to your progress....subscribed:)

Lyle....I wish I saw this sooner! Our builds are similar in some ways regarding open bays and a loft...other than that, very different. I was going to mention that your lift area is going to be very very tight....I know because I have the same problem....I actually am considering a single post...

which way did you decide on your siding? rough in or out? nice progress looking good.

thank you SIGma....more interior shots

some interior shots....work bench area...etc

Up here in my neck of the woods that price will get you a small piece of ground to build on, if you are lucky. Nice job!

Very nice!!!:) I always check out this site for ideas and there are so many different styles and tastes too be appreciated...as a Landscape Contractor I cant believe you were that neat about your trenching:eyecrazy:, but then I saw the lawn:rocker: Very Nice Build!!!

actually i think its 42....and its not the rubber...its the bearing (get a lil dust in there and forget it)....my plan is to retro fit the bottom cab with quality casters when the time comes....but the box and chest set me back 700 and change.. it was marked down 200 and change...and its for my...

last winter....during construction

I have the Harbor Freight set up.....also 2 craftsman rollers...and a small Matco top chest. I will tell you that when I bought the Harbor Freight set up, I knew It wasn't a Snap On......it also costs 1/5th.....my only real complaint is the casters....my box is only 3 months old and is probably...

On a serious note...lyme *****. I knew ahead of time that with what i do it was only a matter of time....i am located in the hot zone for lyme carrying ticks in the continental US ...we use spray almost everyday, the problem was just that "almost every day" .....if u hunt, fish, hike, or just...