Recent content by slidewayes

3 years later and it's too small

Yes .

Call a concrete cutting co. most do grinding on a hourly rate you could fix that good enough to put an epoxy coting on it ,BUT If the people that did that work for a finish I would question the work you cant see

1post 2500lbs cap spins 360

Done with the paint .Moved the lathe+Mill in

A little more paint to do, Then move the lathe + Mill in , build some workbenches + cabinets getting tired I need to go for a ride and forget about this for a while. Could not do it with out her help

The lift is made by BESTWAY HYDRAULICS 2500 lbs cap. can spin 360 at any height maid in so. cal. they don't answer the phone or emails But if you can get a hold of them it is a grate lift

Drywall up

dry wall up start tapeing tomorrow

there's a start keep it coming

something to cover this

30x35 1050 sq ft when saying foil I'm thinking what you would see in a commercial /tilt up build. Cost is not the deciding factor clean +Quality is

I hate doing / no good at drywall looking at new Idea's for my ceiling living in the So Cal desert cold is not a problem Hot I can handle but I would like to separate the shop from attic pictures are good thinking of just an alum. foil paper ?

Got lift in and some drywall up . the core is from the lift then auger out 56"of dirt had it installed in about an hour or so

MECO is out of business ,Wisconsin too .This is a Husqvarna has a 4cyl turbo charged import and a 3 speed trans The axel can be locked or not Think it is rated at 45/50 HP can swing a 36" and not brake a sweat