Recent content by Smbevma

I painted an old scooter body part with SEM custom fill 1 part and the result is not as glossy as I would like. I've used Spraymax in the past for other applications, so I'd like to apply this over the single stage paint. My question is what is the best surface prep. I have very slight orange...

I'm purchasing a 12x24 shed with a garage door and a wood floor to store scooters, motorcycles and some other things. A shed that size could conceivably be used as a garage for a car if I ever sell my house. I checked the span load of the 2x6 joists and they are more than adequate for a 50lb...

What if I ran an in line filter to catch the water before it goes into the pvc conduit, and then still blew the air out when I'm done? Since the pipe is buried 18" there's no practical way to install a drain.

Hi: I'm thinking of putting a 5HP 60gallon compressor in a shed I want to build. I want to also tap this air supply in my garage, which is about 40 feet away. Since I have to dig a trench for an electrical conduit I was thinking of running a PVC conduit in the same trench an then threading a...

Hi: I'm new to the forum and posted this yesterday, someone kindly suggested this in the subforum so here I am. I'm thinking of building a purchasing a shed for scooters and small cars I have (12x24'). I'd also like to put a 5HP 60 gallon 230V compressor in the shed. Because of site/cost...

Hi: I'm thinking of building a shed for scooters and small cars I have. I'd also like to put a 5HP 60 gallon 230V compressor in the shed. Because of site/cost considerations I'm purchasing a shed with a wood floor, 5/8 plywood on 2x6PT joists 8" on center. I'm a little concerned that the...