Recent content by speedshop

Ok zip ties will work

Metal strap and sheetmetal screw

Here is the product page https://emaxcompressor.com/products/7-5-hp-silent-air-compressor-2-stage-v4-1-phase-80-gallon/ 32 amp running 50 amp breaker

I will be running the cable on a steel beam 10’ up so not concerned about not being in conduit.

Picked up a new compressor for the shop, 7.5hp single phase. I need help picking out what wire to order. It says #6 wire if under 50 ft or #4 if over 50 ft. I will be right at 60 ft from the breaker box. I have a 200 amp service and want to use wire that is in the flexible metal coving to...

Been running the heater for a month with no issues, recently it has a terrible vibration-drone noise. Sounds like a lose panel but everything checks out. I did figure out if you shut the thermostat off it immediately stops the noise. Also the noise isn't present at first start up, it takes 10...

Yes I forgot to add location. Bowling Green Ky

I have a 50X100 with 14’ ceiling that is insulated pretty good with a hanging Moline natural gas heater. I’m curious if you guys think its cheaper to leave the thermostat set at 63 or turn down to say 50 at night and turn up to 63 when i arrive in the mornings. I work in the shop Mon-Fri so the...

It’s a direct drive with cables, no grease on cables. I sprayed some silicone in the coroners but no change.

I'm having issues with my new Atlas 2 post lift. When raising the arms vibrate then mis way starts getting bouncy. Posts are perfectly level, no air in the system. Anyone have similar issues?