Recent content by Speer

I was looking at the small 5 or 15 gallon tanks and think that will be the way to go. I do use hot water everyday to mix up milk replacer for calves, but it's only about 2 gallons at a time.

I am currently wiring/finishing my building and have plumbed for a bathroom. Anybody have any suggestions for a water heater? I really don't have a preference between a tank/tankless, but I do think electric would be easier for me. If propane is MUCH better I could make it work. I don't...

cybrdyke Thanks!!! I'l give them a shot.

Do the rab slim ** shine out and down?

I am searching for the best type of light for the outside of my building. I don't need the area lit up enough to perform surgery, but would like the most efficient option. There will be one light centered on the building above my overhead door. I will be hanging it about 16' from the ground...

19Vert64 Thanks! That's what I will do.

I am sure this has been over a million times, but I searched and couldn't find the answer I am looking for. I built a 64'x40'x14' pole building and am planning on putting metal on the inside ceiling. My question is do I need to screw it on 2' centers or will 4' be O.K. I am planning on...

mjchamp: since the door is not installed yet I was thinking about doing this in the sections. Did you do it while it was put together or take it apart?

The building is a standard pole barn. 6-3x4 windows, 2 walk doors, 2 overhead doors 12x12 and 20x12. r-19 walls/r-30 blown in ceiling. I may be figuring wrong, but I came up with 67-14' sheets for the walls and 43-20' for the ceiling. Each covering 3' width. They said $1 per square floor...

Hello, I am planning on lining the inside of my building with metal, and was wondering if anyone could point me in a direction with some plans. The building is 40x64x14 sidewalls. I got a price from the guys putting up the building and it was about $11,500 for materials (including...

Hello, I am getting ready to put up a new shop, and was told at first they could match the overhead doors to the wainscoting. Now I may have misunderstood them or was told wrong, but now they say the door colors won't match the sides. Does anyone know where I could get overhead doors to...

Hello, I am a new member here so not sure if this is the right place to post this, but I am searching for a hook that goes in metal pegboard. The hook is threaded on the end so it stays in place when tightened with a wing nut. Also, I am not sure if the whole thing is Craftsman or not, but...