Recent content by spyhunter

http://www.sears.com/shc/s/p_10153_12605_00961015000P Does anyone have these tiles? They look comparabile to racedeck, but I'd hate to by a box of them only to be disappointed.

I'm rebuilding mine as well. Basically, mine was the complete opposite. Every joint had play it in or wobbled. I also ordered new track bearings (#15 on the diagram) and tightened up just about every joint in the manual. It's better, but still isn't perfect. On mine, there is a small amount of...

Have you had any durability issues using osb for cabinet construction?

give Bryce a try, it's free for personal use

home depot has a kit, 75 bucks for a 1 car. it's the pink stuff with a vinyl backing

I have a 2 car garage that is attached to the house on 1 and half walls with a bedroom over half of the garage. This means that the walls that are attached to the house are insulated and half of the ceiling. I'd would like to insulate the remaining walls and attic space within the garage. My...

I'm not really sold on any of the plastic floor tile systems. Racedeck is arguably the best, and I was able to easily and permanently mark up the sample tile by putting it under a loaded floor jack and under jack stands. It did withstand every chemical I have, but the marring is troubling. If...

18 x 20 garage here, i take most of the long flat components apart and store it under the workbench, the rest sits in the corner

cool, nice fx. Mine has had all kinds of electrical issues, bad fuel level sender, cam sensors and now a bad fuel injector. 98k, but we still love it.

Are your jack and jackstands always going to be in the same spot every single time? I just got a few more samples from floor junkies and greg smith equipment.

I've been testing racedeck type flooring with similar results. Jackstands and a loaded rolling jack leaves permanent marks on the tiles. An unloaded jack does not seem to leave marks.

I do a ton of car work. I recently received a racedeck sample and have been testing is over the past few weeks. As far as chemical resistance, I've tried soaking everything that I had on it with no apparently failures or weaknesses. Jacks and jack stands are a different story. Rolling a car...

What kind of contraption do you have holding the latter to the ceiling?

I have that setup. I picked it up for around 150 bucks on sale. It is literally about half the thickness of steel used in a comparable craftsman model at half the cost. I haven't had any issues with it and it does the job. I'd spring for some better drawer liners. I don't regret the purchase at all.

they make threshold and rubber seals for garage doors, check home depot or equivalent