Recent content by squarles67

As someone already said, they are standard NPT thread so they'll work just fine.

I have had some success using 308 stainless wire and helium tri-mix. I welded stainless v-bands for a turbocharged 55 Chevy project I'm working on. Not finished so I haven't run it yet. Sorry for the blurry cell phone pic but that's all I have. I tried regular mild steel wire and CO2-Argon at...

That's the one I used. Did the very same thing, changed the house from overhead to underground and fed the shop from it. Power Co charged me about $1500 I think plus the cost of the meter box and conduit. I needed to move the overhead service to the house because the pole was in the way for...

looks like a backflow preventer to me. The bolt going through is the pivot

I had mine done by Mallett in Iowa LA, but I'm not sure how far North they go. They did an excellent job. http://mallettbuildings.com/

I bet the Long Beach port is a big part of it. It took me a while here recently to find the Gantry Crane in stock at the HF in Beaumont

I just wear a cap and stick the pencil under the edge near the temple

10-32 and 10-24 are the ones I use the most of

I got mine on Ebay from this seller http://www.ebay.com/itm/RapidAir-MaxLine-Compressed-Air-Piping-System-Outlet-Kit-M7510-/271320673319?pt=LH_DefaultDomain_0&hash=item3f2bf8ec27

Being hard headed helps (although my wife doesn't see it so much as a virtue)

Came home to the sounds of running water......had a fitting burst on my new plumbing and flood the place.:sad: Hellava mess but got it cleaned up. Don't have all that much stuff in there yet so nothing ruined. I hate plumbing, I have much more respect for the guys that do it for a living after...

Here are pictures of an old vise that was attached to a welding table I just picked up. It's been welded back together at one time or another. The jaws are actually in very good shape. Any idea how old this thing is?

Same goes for that twin turbo Buick of yours :thumbup: Scaffold builder huh....same here although I haven't actually built any in the last 15 years lol

No pictures but I've also sealed the concrete with RadonSeal http://www.radonseal.com/radonseal-mitigation.htm Plumbed my air lines with 3/4 max line by Rapid Air. Hooked up my free compressor (had to fix the motor) Put OSB on the lower walls to protect the insulation. Ready to start with...

Now working to finish out the inside. I'm enclosing part of the inside to insulate and add air and heat with a bathroom. 12' x 30' framed I had some guys from church helping me and they said they had some plywood for free for the wall behind the back bench. Before After, they thought it...